YRabbit

The light works. The gravity works. Anything else we have to take our chances with.

One, two, three, and the camera from the past is ready.🙂 #diy youtube.com/watch?v=_3n2b0…

#PidiBoy mini game console with CH32V006F8P6 processor and OLED I2C B&W display 128x64 pixels SSD1306. Console is completed, tested, systems fully functional, and 25 games are ready for it. www breatharian.eu/hw/ch32libsdk/… , GitHub github.com/Panda381/CH32L… . @pajenicko @Electro_L_I_B

Gee! Logical operations (in this case OR-NOT) are working in the GW5A family! :) The inversion is necessary because the LEDs are connected like this. #fpga#apicula#sipeed#gowin

The cactus has bloomed. This miracle goes home for the winter - it's not Mexico after all🤣 #gardening

Well with this print orientation (huge horizontal area with supports) it's just a great result! It was impossible to print at a tilt - allis held on the edge screws and there should be no inter-level connections between them, the levels should go through both screws. #3dprinting

Or make standard ones but use one of these isolation methods:🤣 #3dprinting youtube.com/watch?v=BOG9Li…

"Adjust settings for optimal performance" True and completely useless advice in the world of #3dprinting.🤣

Yes, definitely the IO bits (#Tangprimer25k) are not set in the IO cell itself, but in the neighboring column or neighboring row. As usual this is not always the case.🤣 Will look for.#fpga

At the moment ARM GPU drivers are the weak link, if it doesn't work with your GPU you're obviously better off with a N100, but I'm working hard to improve that.

Broke the thing in Toyota, interesting shape, I'll have to sweat drawing in #FreeCAD first and then choosing print orientation - those smooth transitions are usually a pain in the ass.😜 #3dprinting